Jump to content


Photo

Failed WOF! :(


  • Please log in to reply
1 reply to this topic

#1 Oscar

Oscar

    Boosted!

  • Members
  • 739 posts
  • Location:Dunedin
  • Vehicles:
    • '96 BG9 Grand Wagon

Posted 04 August 2012 - 1:34 AM

As the title says, totally not cool. One of the big ones is one of the bolts mounting the seat was 1/2 way out. Turns out it was cross threaded and it's pretty much fucked the thread in the hole. Not only that, it's one I've never seen on a Subaru before. I'm used to seats with 4 bolts to mount, but not 5!

I have an idea but I want to know if it's okay for the recheck before I go ahead. I want to grind off the nut thing welded underneath the car with the fucked thread and just run a standard nut and bolt through the hole instead. If that isn't going to cut it I'll just get the thread retapped, but I figured to check before grinding shit off.

Pull your handbrake just enough so the light comes on. That sends the ECU into full race mode.

'90 BF5 TZ - RIP
'90 BF5 GT - RIP
'86 AG9 RXII - RIP
'90 BC5 RS-RA - RIP
'90 BF5 GT - RIP
'94 BG5 TS - RIP
'96 BG9 GW

#2 Ichi Ban

Ichi Ban

    SOHC-powered

  • Senior Member
  • 166 posts
  • Location:Welly
  • Vehicles:
    • 09 Impreza Hatch 2.0R Sport (NZ New)
      07 Toyota VX Prado (NZ New)

Posted 04 August 2012 - 9:12 AM

all bar the middle rear mount of the nuts are inside the chassis

if you can get the bolt out , you should be able to re tap the thread and replace the bolt




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users